APPLICATION: All LS, Vortec and LT PSI standalone harnesses

PARTS INCLUDED: 6ft 1” braided loom, 15ft 1/2” braided loom, 22ft 1/4” braided loom, 15ft 1/8” braided loom, 2 rolls Stretch and seal tape.

NOTES: PSI braided woven loom is a flexible, semi-rigid material, with a tough woven texture and appearance to enhance the look and protect the wires in any automotive engine compartment. The woven construction provides good drainage while maintaining superior abrasion resistance. The split loom design has a minimum overlap of 25% to allow for easy installation and optimum wiring protection. Continuous Temperature Rating -94°F to 257°F, Melting Point 482°F
Write a Review
- 07/18/2021
  
  Excellent product.
  
  Installed an LS 5.3 into a 1939 Ford Coupe Deluxe. The install went smooth and the engine fired right up.
  
  STEVE
  
  -
  
  Emporia, Ks.
  
  Was this review helpful?
  
  Yes (0)
  
  No (0)

Looking for an Affordable, In Stock, Plug and Play wiring harness for your LS Swap? PSI sells Standalone Wiring Harnesses for GM Gen II, III, IV, & V LS/LT based engines and transmissions. These harnesses include the Gen II LT1/LT4, Gen III (24x) LS1/LS6 and Vortec Truck Engines as well as Gen IV (58x) LS2, LS3, LS7, & Vortec and GEN V LT / ECOTEC3 Engines. All PSI Harnesses are Made in the USA and are 100% Computer Quality Tested. In addition to wiring harnesses, PSI carries Holley Products, Vintage Air A/C, Dakota Digital Gauges, HPTuners and PCM programming, Fuel Pump Kits, Engine Sensors, Extension Harnesses, Replacement GM connector pigtails and a complete line of hardware to complete your conversion!

My Cart

DIY braided woven loom kit

Customers Also Purchased These Related Items

About

Help

My Account

Contacts