Dirty Dingo adjustable transmission crossmember bolts into 2WD 1963-1987 C10 C20 Truck's, Blazer's, and Suburban's. This crossmember, in most cases, will bolt to the frame using existing transmission mounting holes. This adjustable crossmember will allow you to run a powerglide, TH350, TH400, 700R4, 4L60, 4L65, 4L70, 4L75, 4L80, 6L80, and 6L90 and adjust the crossmember without drilling any new holes into your frame. This is designed for lifted or lowered trucks and will retain the factory transmission angle for proper driveshaft alignment. CNC bent 1 3/4" diameter tubing with 1/4" plates that will clear long tube headers and exhaust up to 4" in diameter. Crossmember is above frame rails and will clear when laying the frame on the pavement. Includes grade-8 bolts, washers, and teflon locking nuts for installation. Welded and cooled in a custom fixture for precision fit.

* Plain raw steel

Looking for an Affordable, In Stock, Plug and Play wiring harness for your LS Swap? PSI sells Standalone Wiring Harnesses for GM Gen II, III, IV, & V LS/LT based engines and transmissions. These harnesses include the Gen II LT1/LT4, Gen III (24x) LS1/LS6 and Vortec Truck Engines as well as Gen IV (58x) LS2, LS3, LS7, & Vortec and GEN V LT / ECOTEC3 Engines. All PSI Harnesses are Made in the USA. In addition to wiring harnesses, PSI carries Holley Products, Vintage Air A/C, Dakota Digital Gauges, HPTuners and PCM programming, Fuel Pump Kits, Engine Sensors, Extension Harnesses, Replacement GM connector pigtails and a complete line of hardware to complete your conversion needs!

My Cart

63-87 Adjustable 2wd C10 C20 Automatic Transmission Crossmember

Customers Also Purchased These Related Items

About

Help

My Account

Contacts